My Maple has arrived!
I ran through the Quickstart guide (http://leaflabs.com/docs/maple/quickstart/ ), and had a couple of problems.
1. The Quickstart guide says the HelloWorld example is under the File -> Examples -> Maple menu, but it is actually under File -> Examples -> Stubs.
2. When I first ran up the IDE, there were no entries in Tools -> Board. When I stopped the IDE, and restarted, it was all fine.
It might be worth giving a short overview of the sequence of events at the start of the guide, e.g.:
1. Download and install Maple IDE.
2. Plug in Maple, and accept network 'unconfigured" ...
3. Start Maple IDE, and upload Blink Test
4. Upload HelloWorld, and open Serial Monitor
Or whatever the right sequence is.
I think I read the detailed text, and used a sequence which didn't quite work, which might be off putting for a beginner.
3. I uploaded the HelloWorld, ran it, and everything was fine, so I changed the code, uploaded again, and the Serial Monitor said the USB device wasn't found. I closed and opened it, and everything was fine. This is a small rough edge, which may need pondering on. Maybe mention in that part of the Quickstart guide the need to close the Serial Monitor.
HTH - GB
