Hi, I need urgent advice, as follows:
All of a sudden, my 2 boards will not load program, but will show a long red error message as shown below. (on WinXP 32, same as always!)
The previously loaded program runs, resets and maple program reload did not make a difference.
I also noticed that one board has its USB port as a serial one, the other is shown as a pure USB port, but both will not load, and show the same error.
This to me is a catastrofic situation, as I need to present my program after making some minor changes.
Thanks
samtal
Here is the full shown message:
Going to build using 'armcompiler' (ARM)
Compiling core...
No libraries to compile.
Compiling the sketch...
Linking...
Computing sketch size...
E:\DOCUME~1\SAM~1.TAD\LOCALS~1\Temp\build1812029404505690763.tmp\WaferMapping08.cpp.bin :
section size addr
.data 17984 0
Total 17984
Binary sketch size is reported above. Check it against a 108000 byte maximum.
Loading via dfu-util
Resetting to bootloader via DTR pulse
java.io.IOException: No error in nativeDrain
at gnu.io.RXTXPort.nativeDrain(Native Method)
at gnu.io.RXTXPort$SerialOutputStream.flush(RXTXPort.java:1201)
at processing.app.Serial.write(Serial.java:470)
at processing.app.Serial.write(Serial.java:492)
at processing.app.debug.DFUUploader.emitResetPulse(DFUUploader.java:170)
at processing.app.debug.DFUUploader.uploadViaDFU(DFUUploader.java:100)
at processing.app.debug.DFUUploader.uploadUsingPreferences(DFUUploader.java:57)
at processing.app.Sketch.upload(Sketch.java:1473)
at processing.app.Sketch.exportApplet(Sketch.java:1405)
at processing.app.Sketch.exportApplet(Sketch.java:1368)
at processing.app.Editor$45.run(Editor.java:1965)
at java.lang.Thread.run(Thread.java:619)
Searching for DFU device [1EAF:0003]...
dfu-util - (C) 2007-2008 by OpenMoko Inc.
This program is Free Software and has ABSOLUTELY NO WARRANTY
Couldn't find the DFU device: [1EAF:0003]