IDE is readonly? « LeafLabs Garden

IDE is readonly?

(4 posts) (3 voices)

erg144
Member

For some reason, I can no long type into the IDE for editing. I'm not sure when this happened or the exact conditions, but no keyboard entry is accepted.

I can still load up any program, still compile and still download the to the maple, I just can not modify or create anything new.

I've tried all of my limited tricks (like reboot, make sure the directories and read/write, etc) with no luck.

I can not find any logs or messages about what is happening, nor when I start from the command prompt does anything go into the command window.

Any ideas?

thx

Posted 4 years ago #
robodude666
Member

Is the code editing window "greyed" out? If you go into preferences, there's an option to enable external editor mode (read-only for the MapleIDE). You might of enabled that by mistake.

Posted 4 years ago #
erg144
Member

That was the problem. Thanks for the quick response.

Posted 4 years ago #
HDS
Member

Thanks definitely a lot for anticipating an error, in which I would have been running earlier or later. From a comfortable IDE, I would expect a related advice(see robodude666' post) when trying to edit in such state.

Posted 4 years ago #

You must log in to post.