Hi everyboby, I design my own PCB board, I respected the hardware of Maple board. However I used 103RC, because I had it.
I programmed it w/ maple_boot.bin and maple_RET6_boot.bin too with external JTAG Programmer. In my board blinks quickly 6 times, then blinks slowly. But when I try to make the permanent boot (reset and BUT button next) and reset again, nothing change. This is my first issue.
On the other hand, I'm using win 7 64bits, so the only driver I could install was de DFU, but it works strange. I never can to install the serial driver to use the IDE. I research that the IDE works in XP, I don't know if in 64 bits win 7...
STM32F103RC Permanent Bootloader
(2 posts) (2 voices)-
Lean966
MemberPosted 2 years ago #
Reply
You must log in to post.