http://forums.leaflabs.com/topic.php?id=9358 A place to share, learn, and grow... en-US Fri, 22 Jan 2016 00:23:18 +0000 http://bbpress.org/?v=1.0.2 q http://forums.leaflabs.com/search.php http://forums.leaflabs.com/topic.php?id=9358#post-20743 Fri, 02 Nov 2012 19:54:26 +0000 crenn 20743@http://forums.leaflabs.com/ <p>Also make sure that the LCD is powered by 5V, it can have issues if you don't.</p> <p>It's also true that the linear voltage regulators can sometimes be the cause of the random rebooting issue, I try to run all of my Maples off 5V which works well, but I have also used a 9.6V rechargeable battery fine but with minimal loading (Barometer and XBee Module with the Maple r3) </p> http://forums.leaflabs.com/topic.php?id=9358#post-20732 Thu, 01 Nov 2012 16:36:10 +0000 Spacy 20732@http://forums.leaflabs.com/ <p>I did what you said and the default blink program worked fine. So after slowly going through and adding my code I noticed that when I plugged in the LCD into the system and re-enabled that code that the problem started happening. After reading <a href="http://leaflabs.com/docs/hardware/maple.html#power-regulation-on-the-maple" rel="nofollow">http://leaflabs.com/docs/hardware/maple.html#power-regulation-on-the-maple</a> I realized that I was drawing too much power from the board and lowed my input voltage down to 5V which seemed to work for now. </p> http://forums.leaflabs.com/topic.php?id=9358#post-20647 Tue, 30 Oct 2012 17:52:00 +0000 crenn 20647@http://forums.leaflabs.com/ <p>Try disconnecting everything from the Maple and upload a simple blink program to flash the board LED, does the problem still occur? Are you loading the program into the flash and have the correct board selected?</p> <p>Could you upload your code for us to take a look? I doubt the pre-setup code would be affecting the start up time unless modifications were made to the libraries.</p> <p>What operating system are you using? </p> http://forums.leaflabs.com/topic.php?id=9358#post-20644 Tue, 30 Oct 2012 16:31:36 +0000 Spacy 20644@http://forums.leaflabs.com/ <p>Hey all, </p> <p>I am currently working on a maple rev 5 board with the v0.0.12 IDE. After uploading my code to the board nothing happens except that the status LED stay solid for several seconds before turning off. </p> <p>I have several outputs over both serial and lcd in the void setup() function call that are not being called. I believe that none of my code is being executed. </p> <p>After powercycling the board several times, and waiting for a couple of minutes my code starts executing. </p> <p>Any idea why this is happening? Also is there any pre-setup code, (I.E the lcd declaration) that would take a long time to execute? </p>