http://forums.leaflabs.com/topic.php?id=1320 A place to share, learn, and grow... en-US Fri, 22 Jan 2016 00:25:28 +0000 http://bbpress.org/?v=1.0.2 q http://forums.leaflabs.com/search.php http://forums.leaflabs.com/topic.php?id=1320#post-8086 Mon, 06 Feb 2012 03:10:28 +0000 Cruz 8086@http://forums.leaflabs.com/ <p>Corrections:</p> <p>Connections are:</p> <p>3.3V ----------------------- 3.3V<br /> GND ------------------------ GND<br /> SCL ------------------------ Pin 5<br /> SDA ------------------------ Pin 9<br /> IR+ ------------------------ 3.3V </p> http://forums.leaflabs.com/topic.php?id=1320#post-8085 Mon, 06 Feb 2012 01:51:54 +0000 Cruz 8085@http://forums.leaflabs.com/ <p>Hello,</p> <p>I'm trying the code found here: <a href="https://github.com/adafruit/VCNL4000/blob/master/vcnl4000.pde" rel="nofollow">https://github.com/adafruit/VCNL4000/blob/master/vcnl4000.pde</a> with my breakout board on my maple board. I'm getting no output. It seems like nothing is being read. I only get some readings when i put a print statement in the loop and comment out everything else. </p> <p>Connections are:</p> <p> 3.3V ----------------------- 3.3V<br /> GND ------------------------ GND<br /> SCL ------------------------ A5<br /> SDA ------------------------ A4<br /> IR+ ------------------------ 3.3V</p> <p>Also, I noticed that whenever I print something in the setup() function, I don't see it on the output? Why is that? It seems like all i can do is Wire.begin(9, 5) inside the setup function and even then, I'm not sure if that will work with the maple. </p> <p>Please help.</p> <p>Cruz </p>