http://forums.leaflabs.com/topic.php?id=599 A place to share, learn, and grow... en-US Fri, 22 Jan 2016 00:19:04 +0000 http://bbpress.org/?v=1.0.2 q http://forums.leaflabs.com/search.php http://forums.leaflabs.com/topic.php?id=599#post-3346 Wed, 12 Jan 2011 15:28:56 +0000 poslathian 3346@http://forums.leaflabs.com/ <p>messiahandrw please email us at info at leaflabs dot com and well see what we can do for you! </p> http://forums.leaflabs.com/topic.php?id=599#post-3312 Fri, 07 Jan 2011 04:04:00 +0000 MessiahAndrw 3312@http://forums.leaflabs.com/ <p>Soldering the connector on proved too difficult. Some of the metal strips where connected to the Maple, some where connected to the USB connector. Instead I finely scratched some of the coating off the circuit board and soldiered the wires from a USB cable straight into the board. Now it permanently has a USB cable attached.... </p> http://forums.leaflabs.com/topic.php?id=599#post-3303 Thu, 06 Jan 2011 13:39:47 +0000 Adam 3303@http://forums.leaflabs.com/ <p>Or you can use the JTAG interface to flash programs on the device if you have a JTAG Debugger and adapter cable/board. For instance, see:</p> <p><a href="http://wiki.leaflabs.com/index.php?title=Maple_JTAG_How_To#Reflashing_the_bootloader" rel="nofollow">http://wiki.leaflabs.com/index.php?title=Maple_JTAG_How_To#Reflashing_the_bootloader</a> </p> http://forums.leaflabs.com/topic.php?id=599#post-3302 Wed, 05 Jan 2011 22:32:48 +0000 MessiahAndrw 3302@http://forums.leaflabs.com/ <p>There possibly isn't a way I can mail this back for a repair? </p> http://forums.leaflabs.com/topic.php?id=599#post-3300 Wed, 05 Jan 2011 14:35:04 +0000 ianmga 3300@http://forums.leaflabs.com/ <p>You can use an FTDI USB to serial adapter, hook it to the USART1 pins, and flash it directly (make jtag) using the ROM bootloader (but I think this is more cumbersome than trying to solder the USB connector back) </p> http://forums.leaflabs.com/topic.php?id=599#post-3298 Wed, 05 Jan 2011 07:39:32 +0000 MessiahAndrw 3298@http://forums.leaflabs.com/ <p>Hello, I have been using my Maple a lot today and I think the USB connector on the Maple board kept getting looser until eventually it feel off. :/</p> <p>I can still power the board but is there an alternative way I can flash my code onto it? </p>