http://forums.leaflabs.com/topic.php?id=2394 A place to share, learn, and grow... en-US Fri, 22 Jan 2016 00:08:11 +0000 http://bbpress.org/?v=1.0.2 q http://forums.leaflabs.com/search.php http://forums.leaflabs.com/topic.php?id=2394#post-12439 Wed, 15 Aug 2012 04:26:38 +0000 asterix 12439@http://forums.leaflabs.com/ <p>Thanks Crenn. </p> http://forums.leaflabs.com/topic.php?id=2394#post-12331 Sun, 12 Aug 2012 08:15:29 +0000 crenn 12331@http://forums.leaflabs.com/ <p>A fully charged LiPo cell is 4.2V however the nominal voltage of the cell is 3.7V. The LiPo charging IC can only handle a single cell and it would not be recommended to use a 7.4V pack as this will damage the IC most likely, using it on the EXT connector should be ok though. </p> http://forums.leaflabs.com/topic.php?id=2394#post-12329 Sun, 12 Aug 2012 02:04:50 +0000 asterix 12329@http://forums.leaflabs.com/ <p>Thanks robodude </p> http://forums.leaflabs.com/topic.php?id=2394#post-12325 Sat, 11 Aug 2012 21:22:40 +0000 robodude666 12325@http://forums.leaflabs.com/ <p>The charger being used is the <a href="http://www.ti.com/product/bq24010">BQ24010</a>.</p> <p>Datasheet says it charges at a rate of 4.2V, so no... probably won't work with a7.2v battery or it'll charge really slowly. Not entirely sure. It's also designed for single cell batteries FYI. </p> http://forums.leaflabs.com/topic.php?id=2394#post-12323 Sat, 11 Aug 2012 20:31:44 +0000 asterix 12323@http://forums.leaflabs.com/ <p>Can the lipo charger handle any voltage? I have a 7.2v lipo battery, 800mah. Not sure if it is a 3 or 4 cell but I'm sure it would be one or the other. I don't want to damage or explode my battery so best to be certain before I go plugging anything in. </p>