http://forums.leaflabs.com/topic.php?id=1304 A place to share, learn, and grow... en-US Fri, 22 Jan 2016 00:09:37 +0000 http://bbpress.org/?v=1.0.2 q http://forums.leaflabs.com/search.php http://forums.leaflabs.com/topic.php?id=1304#post-10209 Sat, 14 Apr 2012 23:53:59 +0000 brucemellen 10209@http://forums.leaflabs.com/ <p>Thanks for posting what you figured out. Perhaps it should be put with the DOCS/maple-ide-install.html ??? </p> http://forums.leaflabs.com/topic.php?id=1304#post-7865 Wed, 25 Jan 2012 22:25:42 +0000 smath 7865@http://forums.leaflabs.com/ <p>Nevermind. I just figured it out. In case anyone else runs into the same problem, once the DFU driver is installed, you just need to open device manager while the board is not in perpetual bootloader mode and update the driver, selecting the driver&gt;serial folder. </p> http://forums.leaflabs.com/topic.php?id=1304#post-7864 Wed, 25 Jan 2012 21:31:50 +0000 smath 7864@http://forums.leaflabs.com/ <p>Okay, so using the instructions on the IDE installation page (<a href="http://leaflabs.com/docs/maple-ide-install.html" rel="nofollow">http://leaflabs.com/docs/maple-ide-install.html</a>) I'm able to get the DFU driver working. I can now upload the blink sketch and change the rate at which it blinks and everything. The problem is that I was never prompted to add the serial driver as the instructions said I would be. When I run the IDE I go to tools&gt;serial port, and it's grayed out. How can I get the serial driver installed? </p>