http://forums.leaflabs.com/topic.php?id=1216 A place to share, learn, and grow... en-US Fri, 22 Jan 2016 00:15:15 +0000 http://bbpress.org/?v=1.0.2 q http://forums.leaflabs.com/search.php http://forums.leaflabs.com/topic.php?id=1216#post-7368 Fri, 16 Dec 2011 17:29:54 +0000 poslathian 7368@http://forums.leaflabs.com/ <p>thats right. no other changes. Thats why its a "RET6 Edition" rather than a fancy new product. Its a good thing too because the RET6 would have aged out very quickly now that an stm32f4 based Maple II is in the works! </p> http://forums.leaflabs.com/topic.php?id=1216#post-7344 Tue, 13 Dec 2011 22:36:57 +0000 mikep 7344@http://forums.leaflabs.com/ <p>I think there are no other changes. On the LeafLabs store website it says this about the RET6:</p> <p>"We have not had a chance to make a whole new Maple version based around the RET6 yet. However, the two chips are pin compatible, so we have produced a limited run of standard Maple Rev5s where in place of the RBT6, we have substituted the RET6 processor! "</p> <p>I have both boards (standard Rev5 and a RET6) and I didn't see any visual difference between the two.</p> <p>Mike </p> http://forums.leaflabs.com/topic.php?id=1216#post-7338 Tue, 13 Dec 2011 15:59:00 +0000 kab 7338@http://forums.leaflabs.com/ <p>hi!</p> <p>i would like to know - if i desolder STM32F103RBT6 from my Maple Rev5 and buy and solder STM32F103RET6 - i'll have Maple RET6 Edition or some more hardware changes is required?</p> <p>thanks!</p> <p>/kab </p>